Azek Deck Uživatelský manuál stáhnout pdf

SET AND SQUARE

Set the ﬁrst deck board on the substruc-

ture and square the board to the fram-

ing. Notice how the ends of the boards

overhang the edge of the framing.

NOTE: If you cut the deck boards to their exact length

prior to installing, fasten the boards immediately after

cutting to limit expansion and contraction. (Refer to

“Expansion/Contraction”.)

NO PRE-DRILLING

Drive screws through the deck board as

shown above. Use two screws per joist to

secure properly.

SCREW DEPTH

To contersink your screws, adjust the

depth on your driver to drive the screw

to a depth of 1/32” to 1/16” below the top

surface of the deck board. For best results,

the screws should slightly penetrate the

surface, similar to installing dry wall.

BUTTING BOARDS ON A RUN OR MITER

Ends should ﬁt tightly together. Use two

screw fasteners per board end. Place

screws within 1/2” of board end (coun-

tersinking slightly). Fastners should be

properly fastened to underlying joist.

16" CENTERS | 12” CENTERS

This completed deck substructure is

ready for installation.

Use 12” on center when deck boards are

not applied Perpendicularly (90° angle)

to the joists, and on commerical applica-

tions.

SCREW SPACING

When fastening, always position screws

3/4” to 1” from the side of the board.

AZEK Deck components should not split

or crack if screws are needed closer to

the edge.

AZEK Deck should be installed using the same good building principals used to install wood or composite decking and in accordance with the local

building codes and the installation guidelines included above. AZEK Building Products Inc. claims no liability or responsibility for the improper installation

of this product. Since all installations are unique, it is the sole responsibility of the installer to determine speciﬁc requirements in regards to each decking

application. AZEK Building Products recommends that all designs be reviewed by a licensed architect, engineer or local building ofﬁcial before installation.

BASIC INSTALLATION